本文二维码信息
二维码(扫一下试试看!)
基于熔融沉积成型的木质材料3D打印技术研究进展
Research Progress in 3D Printing of Wood Materials-based on Melt Deposition Molding
投稿时间:2024-05-08  
DOI:10.11980/j.issn.0254-508X.2024.11.007
关键词:  木材加工剩余物  熔融沉积成型  木质材料  3D打印  强度性能
Key Words:wood processing residues  melt deposition molding  wood materials  3D printing  strength properties
基金项目:云南省Dongyang Li院士工作站(202305AF150019);云南省教育厅科学研究基金项目“基于农作物秸秆纤维素材料3D打印研究”(2022J0501)。
作者单位邮编
田战勇 西南林业大学机械与交通学院云南昆明650224 650224
陈继飞* 西南林业大学机械与交通学院云南昆明650224 650224
陈文刚 西南林业大学机械与交通学院云南昆明650224 650224
向国 西南林业大学机械与交通学院云南昆明650224 650224
江有利 西南林业大学机械与交通学院云南昆明650224 650224
黄斯声 西南林业大学机械与交通学院云南昆明650224 650224
摘要点击次数: 187
全文下载次数: 118
摘要:近年来,天然填充材料聚合物在3D打印领域得到了广泛应用。木质材料因其可再生、环境友好等特点,在3D打印领域受到广泛关注。本文首先介绍了木质材料的来源和制备方法,指出目前国内木材加工剩余物利用率不高,利用方式少的问题,通过在木材加工剩余物的利用上加大创新,与3D打印技术相结合以提高其利用率。接着详细论述了3D打印熔融沉积成型技术原理与成型方式,并根据木质材料特性及成型工艺,对其性能进行归纳与论述,分析木质材料熔融沉积成型存在的问题并展望其发展趋势。
Abstract:In recent years, natural filler polymers have been widely used in the field of 3D printing. Wood materials are gaining attention in the 3D printing field due to their renewable and environmentally friendly properties. This paper first introduced the sources and preparation methods of wood materials, and pointed out that the utilization rate of wood processing residues in China was not high at present, and the utilizations were few. Through increasing innovation in the utilization of wood processing residues, the combination of 3D printing technology could improve its utilization rate. Then, the principle and molding method of 3D printing melt deposition molding technology were discussed in detail, and its performance was summarized and discussed according to the characteristics and molding process of wood materials. The problems existing in wood materials melt deposition molding were analyzed and its development trend was forecasted.
查看全文  查看/发表评论  下载PDF阅读器